This is essentially a 12-point sinc resampler, unless it's resampling to a rate
higher than the output, at which point it will vary between 12 and 24 points
and do anti-aliasing to avoid/reduce frequencies going over nyquist.
Code provided by Christopher Fitzgerald.
The EAX-only effect properties will be set to compatible defaults when standard
reverb is set, and the EAX-only effects will be skipped during sample
processing.
If the filter properties are continually updated, and the HF or LF gain goes
from <1, to 1, and later back to <1, the history shouldn't hold stale values
from before it was at 1.
The extension's not going anywhere, and it can't do anything fluidsynth can't.
The code maintenance and bloat is not worth keeping around, and ideally the AL
API would be able to facilitate MIDI-like behavior anyway (envelopes, start-at-
time, etc).
This helps avoid different results when looping is toggled within a couple
samples of the loop point, or when a processed buffer is removed while the
source is only a couple samples into the next buffer.
The method takes a marked-up filename (e.g. may include %r for a sample rate,
%% for %, etc), and returns a vector of strings of found filenames that match.
It will search the CWD, the local, and global data directories, in that order.
Note that this is the multiple above the device sample rate, rather than the
source property limit. It could theoretically be increased to 511 by testing
against UINT_MAX instead of INT_MAX, since the increment and positions are
using unsigned integers. I'm just being paranoid about overflows.
It's possible for another invocation to increase the array size in between the
ReadUnlock and WriteLock calls, causing the 'i' index to refer to a taken
entry.
Note that it still uses FuMa scalings internally. Coefficients loaded from
config files specify if they're FuMa (in both ordering and scaling) or N3D,
and will get reordered or rescaled as needed.
It seems a simple scaling on the coefficients will allow first-order content to
work with second- and third-order coefficients, although obviously not with any
improved locality. That may be something to look into for the future, but this
is good enough for now.
This basically acts as if the app created a new context with the specified
attributes (causing the device to reset with new parameters), then immediately
delete it. Existing contexts remain undisturbed, except for a temporary pause
while the device output is reconfigured.
Chris Robinson